Welcome, Guest
Username Password: Remember me
  • Page:
  • 1
  • 2

TOPIC: Slightly uneven bevels

Re: Slightly uneven bevels 9 months, 3 weeks ago #5032

  • Jet B
  • OFFLINE
  • Junior Boarder
  • Posts: 35
  • Karma: 6
Well... I am taking her to Mexico for 10 days on a holiday in October.

You just made me realize I should buy some knives and stuff while my brownie points are still active.

Re: Slightly uneven bevels 9 months, 3 weeks ago #5045

  • Allgonquin
  • OFFLINE
  • Junior Boarder
  • Posts: 38
  • Karma: 7
If I want to match a factory bevel, be it reasonably symmetrical or not so much, I always "sharpie" the edges, set up the WEPS angles at a guess to match the edge, and then make a light pass or two with the 1000 grit stone to see how well it matches the edge. Then I adjust the angle to get the most coverage of the edges, i.e. the most ink removal on each side. The I go back and work the progression from coarse to fine.

Rgds,
Allgonquin

Objects in closer are mirror than they appear
  • Page:
  • 1
  • 2
Time to create page: 1.14 seconds